9
5. Keep the propane cylinder enclosure area free and clear from debris.
6. Clean the Lentek Elite Mosquito Trap outside surface with a mild detergent and a damp cloth. Do Not
Spray with or immerse any part in water.
7. Replacement parts (Regulator with hose, Catch Cup, Ground Stakes) are available from Koolatron Inc.
8. Store the Lentek Elite Mosquito Trap in a cool dry place when not in use and AWAY FROM ANY
CHEMICALS.
9. Occasionally the burner orifice may become clogged with dirt and debris causing the flame to be
small or the trap not to light. Follow the instructions below to clean the burner if the trap will not light
and at the beginning of each mosquito season.
CLEANING THE BURNER ORIFICE
1. Use can of Gum Out brand carburetor cleaner available at most automotive supply shops or an
equivalent product.
2. Attach the straw provided with the can to the can nozzle.
3. Insert the straw through the side of the mosquito trap and, by watching through the window guide
the tip into one of the air holes under the burner.
4. Spray two 1 second bursts from the can.
5. Set the Lentek Elite Mosquito Trap aside and let the interior dry for at least 24 hours.
WARNING
Carburetor cleaner is highly flammable. Do not attempt to light the Lentek Elite Mosquito Trap before
the cleaner has dried thoroughly.
All repairs must be performed only by qualified service personnel.
The heater should be inspected before use and at least annually by a qualified service person. More
frequent cleaning may be required as necessary. It is imperative that the compartment, burner and
circulating air passageways be kept clean at all times.
6. Light the trap according to directions.
To Next Page
Loading...