1
LENTEK ELITE MOSQUITO TRAP
DIRECTIONS FOR ASSEMBLY AND USE
Read before unpacking and operating the Lentek Elite Mosquito Trap.
The Lentek Elite Mosquito Trap requires 120V AC and is for Outdoor Use Only.
FOR YOUR SAFETY:
1. Do not store or use gasoline or any other flammable vapours and liquids in the vicinity of the
Lentek Elite Mosquito Trap or any other appliance.
2. The installation must conform with local codes or, in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1-1998 for US and with the CANI-B149 for Canada.
PARTS LIST (Material is packed on both sides of foam)
Hardware: (1) Thumbscrew
(A) Trap Body
(B) Burner Unit
(C) Upper Body Column
(D) Ground Stakes - Qty. (2)
(E) Catch Cup (installed Trap Body)
(F) Base
(G) Lower Body Support Column
(H) Regulator with Hose (attached to burner unit)
(I) Tank Bracket
(J) Propane Tank Cover
(K) Power Supply
Input:120VAC 60Hz, 71W
Ouput:12VAC @4200mA
(L) Wheels (attached)
To Next Page
