Lentek MK10 - Assembly Instructions; Step 1: Assemble support column to base; Step 2: Attach the Burner Unit; Step 3: Attach upper body support

ASSEMBLY
Step 1: Assemble the support column to the base
Place the base on a flat surface. Insert the support column with the slotted side down as shown.
Press in firmly.
Step 2: Attach the Burner Unit to the top of the support column
Attach the burner unit to the top of the support column as shown. Press the tabs on the sides of
the support column to insert it into the hole in the burner unit. Make sure that BOTH tabs pop
up through the holes in the bottom of the burner unit.
Step 3: Attach the upper body support to the top of the burner unit
Attach the Upper Body Support Column to the top of the burner unit as shown. Press the tabs
on the sides of the upper burner support column to insert it into the hole in the bottom of the
Upper Body Support Column. Make sure that BOTH tabs pop up through the holes in the
bottom of the Upper Body Support Column.
2