34 Information BM2
8.2 Push-pull operation
You can also use the BM2 for push-pull operation. Preferably, the BM2 module will be used where
the rear-powered (pushed) train is to stop. In this case, a BM1 module suffices at the opposite
stopping point.
8.3 Using the BM2 at the end of a block section
You can use the BM2 module to complete a block section of BM3 modules. In a typical case, the
entry signal to a station would be at the end of a block section. By setting the entry signal, you, as
the conductor, determine whether an arriving train may or may not enter the station.
To Next Page
Loading...
