Command Station LZ100 3
DIGITAL plus
Figure 2: Connecting to 2-Rail Figure 3: Connecting to 3-Rail
After connecting all the units, plug the transformer into a power
outlet. The display of the Hand Held Controller will briefly show
“LH100”, then it will display the address of the most recently
used locomotive, along with its data. On first use, the display will
show locomotive address 3 (factory set).
If your digital locomotive has another address, then press “Cl”
key on the Hand Held Controller. Next enter the desired
locomotive address on the keypad and verify it by pressing the
“Enter” key.
Now you can control the speed of your digital locomotive with the
following keys:
If you want to change your locomotive’s direction of travel, first
set the speed to step 0, then press the hexagonal key. The new
direction will be shown in the display.
With the “0” key you can turn the locomotive headlights on and
off (if connected). See your LH100 manual for more details.
To Next Page
Loading...
