THE SCF SUB-MICRO DRIVE
PROGRAMMING
BUTTONS
ELECTRONIC
PROGRAMMING
MODULE (EPM)
INPUT POWER
TERMINALS
3-DIGIT LED
DISPLAY
CONTROL
TERMINAL
STRIP
DC BUS
TERMINALS
OUTPUT (MOTOR)
TERMINALS
Safety Information
All safety information given in these Operating Instruction have the same layout:
Signal Word! (characterizes the severity of the danger)
Note (describes the danger and informs on how to proceed)
Icon
Signal Words
Warning of
hazardous
electrical
voltage
DANGER!
Warns of impending danger.
Consequences if disregarded:
Death or severe injuries.
Warning of
a general
danger
WARNING!
Warns of potential, very hazardous situations.
Consequences if disregarded:
Death or severe injuries.
Warning of
damage to
equipment
STOP!
Warns of potential damage to material and
equipment.
Consequences if disregarded:
Damage to the controller/drive or its environment.
Information
Note
Designates a general, useful note.
If you observe it, handling the controller/drive
system is made easier.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
