What to do if Lenze DC Drives motor does not rotate because wrong parameter set is active?
If the Lenze DC Drives motor does not rotate and the wrong parameter set is active, change to the correct parameter set via terminal.
What to do if Lenze DC Drives motor does not rotate because no motor parameter identification executed?
If the Lenze DC Drives motor does not rotate and the operating mode C0014 = '4' or '5', but no motor parameter identification has been executed, perform motor parameter identification (C0148).
Provides general safety guidelines for Lenze controllers, including handling and installation.
Outlines safety instructions for Lenze low-voltage motors, covering general and application-specific aspects.
Identifies residual hazards associated with the controller's operation and handling.
Details important notes, protection, mains conditions, EMC, and cable specifications.
Outlines checks and preparations required before initiating commissioning.
Details special procedures for long-time storage and protective measures.
Details how to set parameters using the keypad, including installation and display functions.
Details controller behavior during mains interruption, failure, or inhibit.
Explains how to configure analog and digital inputs/outputs for setpoints and actual values.
Describes automatic detection of motor parameters for optimal performance.
Covers I2t monitoring and temperature monitoring of the motor.
Covers detecting failures via LEDs and analyzing errors using the history buffer.
Explains controller responses to TRIP, message, and warning fault types.
Provides causes and remedies for common drive maloperations and error messages.
Details how to reset TRIP error messages manually or automatically.
Covers requirements for external brake resistors for larger inertia or generator mode.
A comprehensive table listing all codes, their settings, and important information.
To Next Page
General