Appendix
Code table
14−33
L
EDB82MV752 EN 5.2
Code IMPORTANTPossible settings
No. SelectionLenzeName
C0358*
Reset node 0
0 Without function
Only for the E82ZAFCC system bus
function module on the FIF interface.
System bus reset node set−up
1 System bus reset
C0359*
System bus status
0 Operational
Only for the E82ZAFCC system bus
function module on the FIF interface.
Only display
1 Pre−operational
2 Warning
3 Bus off
C0360*
Control of process
data channel CAN1
1
0 Event or time control
Only for the E82ZAFCC system bus function
module on the FIF interface.
1 Sync control
C0370*
Activate remote
parameter setting
via system bus
(CAN)
0 Deactivated Only for the E82ZAFCC system bus
function module on the FIF interface.
Can only be read when using all other
bus function modules on FIF.
1 ... 63 Activates corresponding CAN address 1 = CAN address 1
63 = CAN address 63
255 No system bus (CAN) Only display
C0372* Function module
identification
0 No function module
Only display
1 Standard I/O or AS−i
2 System bus (CAN)
6 Other function module on FIF
e.g. application I/O, INTERBUS, ...
10 No valid recognition
C0395* LONGWORD
process input data
Bit 0..15 Controller word (mapping to C0135)
For bus operation only
Sending of control word and main
setpoint in a telegram to controller
In keypad: display only (hexadecimal)
Bit 16...31 Setpoint 1 (NSET1−N1) (mapping to C0046)
C0396* LONGWORD
process output data
Bit 0...15 Controller status word 1
(mapping of C0150)
For bus operation only
Reading of status word and output
frequency in a telegram from controller
In keypad: display only (hexadecimal)
Bit 16...31 Output frequency (MCTRL1−NOUT)
(mapping of C0050)
C0409
Configuration relay
output K2
Output of digital signals to relay K2
Relay output K2 only with 8200 vector
15 ... 90 kW
For operation with Application−I/O only
active as of version E82ZAFA...XXVx2x
7−73
255 255 Not assigned (FIXED−FREE)
Digital signals possible for C0409 see C0415
To Next Page
Loading...