Switch/potentiometer unit E82ZBU
for 8200 motec
MA82ZBU 1.0
Lenze GmbH & Co KG, Postfach 10 13 52, D-31763 Hameln
(
(+49) 5154 82-0, Fax Service: (+49) 5154 82-1112
These Instructions
• describe the installation and handling of the switch/potentiometer unit.
• are only valid
- for switch/potentiometer units with the nameplate data E82ZBU
- together with the Operating Instructions of the corresponding controller.
Description
The switch/potentiometer unit E82ZBU enables
• the selection of an analog setpoint signal for Lenze controllers through the function
modules Standard-I/O and Application-I/O.
• easy control of Lenze controllers through digital inputs of the function modules
Standard-I/O and Application-I/O (e. g. reversal of direction of rotation).
Range of application
To be used with 8200 motec frequency inverters as of nameplate label
E82MVxxx_4Bxxx 0x0x
Items supplied
1 switch/potentiometer unit with pre-cut 2.5 m connection cable
1 mounting sheet 60 mm x 60 mm
4 screws M4 x 30 for mounting the switch/potentiometer unit to the
mounting sheet
2 screws M4 x 20 with spring steel sheet for mounting to the
heatsink of the motec
General data and application conditions
Type of protection IP65
Dimensions (W x H x D) approx.65mmx115mmx85mm
Possible mounting positions Mounting to the heatsink of a
motec
Mounting to a wall
EDK82ZBU
00415671
06/00
To Next Page
Loading...
