Lenze EVS9329EP - Page 332

Appendix
5.2 Index
5−8
l
EDSVS9332P−EXT DE 2.0
Speed control, 2−6
− acceleration and deceleration times, 2−7
− additional acceleration and deceleration times, 2−7
− additional setpoint, 2−7
− additional torque setpoint, 2−9
− controller inhibit, 2−10
− current master value, 2−6
− inverting the main setpoint, 2−7
− JOG setpoint, 2−6
− main setpoint, 2−6
− resetting a fault, 2−10
− S−shaped ramp function generator characteristic, 2−7
− selection of direction of rotation, 2−8
− setpoint selection, 2−6
− speed limit, 2−9
Speed controller, 3−212
− Setting the integral component, 3−212
Speed limit, 2−9
Speed setpoint conditioning (NSET), 3−225
− Additional setpoint, 3−229
− JOG setpoints, 3−227
− Main setpoint, 3−226
− S ramp, PT1 element, 3−229
− Setpoint inversion, Ramp function generator, main setpoint,
3−228
Speed setpoint limitation, 3−213
State bus connection, 3−259
Switching frequency changeover, 3−216
System bus (CAN−IN), 3−132
System bus (CAN−OUT), 3−133
T
Terms
− controller, 5−3
− Definitions, 5−3
− drive, 5−3
Torque control, with speed limitation, 3−213
Torque limitation, 3−211
TP signal, 3−53
travel range limit switch, 3−30 , 3−49
Travel range limits, 3−44
TRIP, 2−10
TRIP reset, 3−162
TRIP set, 3−162
V
Variable tables (VT), 3−75
Preface, 1−1