Mechanical installation
Mounting of g500 short/servo adapters with clamping connection
Mounting of motors to gearboxes with an adapter
4
31
Lenze ¯ MA 12.0018 ¯ 4.1
4.3.7 Mounting of motors to gearboxes with an adapter and a flexible coupling
When mounting a motor to an adapter, be sure to observe a fully circumferential
contact of the flange faces, thus ensuring that there is no aperture to the interior of the
adapter.
With higher degrees of protection or when there is a risk of dirt or humidity entering,
additionally seal the contact surfaces with a suitable sealant.
Fig. 8 Input side design N
Spider / gear rim 1 Locking screw
Coupling hub 2 Keyway
To Next Page
Loading...
