Troubleshooting and fault elimination 10
If faults occur during operation of the drive system :
• First check the possible causes of m alfunction according to the follo w in g table.
1
Note!
Also observe the corresponding chapters in the operating instructions for
the other com ponents of the drive system .
If the fault cannot be remedied using one of the listed measures, please contact the
Lenze Service.
• O nly w ork on the drive system when it is in a deenergised state!
• Hot m otor surfaces o f up to 150 °C. Observe cooling tim es!
• Rem ove loads acting on motors or secure loads acting on the drive!
EN
Lenze • BA 33.0006 • 3.0
45
To Next Page
Loading...
