Why is my Lenze Engine experiencing excessive temperature?
If your Lenze Engine is overheating, it could be due to several reasons. First, check for an overload and reduce the load, ensuring the drive and machine combination is correct. Second, ensure sufficient heat dissipation by improving the cooling air supply and cleaning the gearbox/motor. Lastly, verify the lubricant level and refill as specified.
What to do if Lenze 12 Series drive is at a standstill?
If your Lenze Engine drive is at a standstill, there are a few potential causes. First, check the connection to ensure the voltage supply hasn't been interrupted. Second, verify that the electrical connection is correct and that the nameplate matches the voltage supply. Finally, check for excessive load and reduce it, ensuring the drive and machine combination is appropriate.
Why does my Lenze 12 Series make unusual noise?
Unusual noises from your Lenze Engine can stem from a couple of issues. One potential cause is an overload, in which case you should reduce the load and check the drive/machine combination. Another possibility is damage within the gearbox or motor, which requires contacting Lenze Service.
Details the purpose and scope of the operating instructions.
Defines key terms used throughout the manual.
Describes what is included in the product delivery.
Explains the designation and identification of Lenze drive systems.
Specifies the intended use and limitations of Lenze drive systems.
Covers legal aspects, liability, and warranty conditions.
Outlines the warranty terms and claim procedures.
Defines roles and responsibilities for safe operation.
Provides essential safety guidelines and precautions.
Explains the meaning of pictographs and signal words used for warnings.
Details the modular design and types of gearboxes offered.
Explains torque and speed conversion mechanisms.
Provides weight specifications for different gearbox models and sizes.
Specifies ambient conditions affecting gearbox operation.
Guidelines for proper storage of gearboxes before installation.
Steps required before mounting, including surface cleaning.
Provides general principles for assembling drive systems.
Instructions for fitting components onto output shafts.
Details the procedure for attaching motors to gearbox flanges.
Instructions for installing gearboxes with hollow output shafts.
Guidance on the breather screw's function and initial setup.
Instructions for correctly connecting the motor to the gearbox.
Checks to perform before initial startup of the drive system.
Guidelines for monitoring the drive system during operation.
Specifies recommended service intervals for lubricants and components.
Detailed procedure for draining and refilling gearbox lubricant.
Table showing lubricant volumes for different gearbox models and designs.
Recommendation for professional repair services.
To Next Page
General
