Why is my Lenze Engine experiencing excessive temperature?
If your Lenze Engine is overheating, it could be due to several reasons. First, check for an overload and reduce the load, ensuring the drive and machine combination is correct. Second, ensure sufficient heat dissipation by improving the cooling air supply and cleaning the gearbox/motor. Lastly, verify the lubricant level and refill as specified.
What to do if Lenze Engine drive is at a standstill?
If your Lenze Engine drive is at a standstill, there are a few potential causes. First, check the connection to ensure the voltage supply hasn't been interrupted. Second, verify that the electrical connection is correct and that the nameplate matches the voltage supply. Finally, check for excessive load and reduce it, ensuring the drive and machine combination is appropriate.
Why does my Lenze 12.602.08 Engine make unusual noise?
Unusual noises from your Lenze Engine can stem from a couple of issues. One potential cause is an overload, in which case you should reduce the load and check the drive/machine combination. Another possibility is damage within the gearbox or motor, which requires contacting Lenze Service.
What to do if Lenze 12.602.08 Engine motor is running, but gearbox is at standstill?
If the motor of your Lenze Engine is running but the gearbox is at a standstill, it could be because the fixing elements are missing or defective, so check the attachment. Alternatively, the gearbox itself might be defective, in which case you should contact Lenze Service.
General| Category | Engine |
|---|---|
| Product Series | 12.602.08 |
| Type | AC motor |
| Voltage | 400 V |
| Frequency | 50 Hz |
Defines roles and responsibilities for safe operation of drive systems.
Provides essential safety precautions for operating and handling drive systems.
Explains pictographs and signal words used to convey important safety information.
Covers the procedures and general information for installing gearboxes.
Offers general advice and safety measures for assembling drive systems.
Explains the correct procedure for connecting the motor to the gearbox.
Lists checks to perform before the initial startup of the drive system.
Provides guidance on monitoring the drive system during operation and handling interferences.
To Next Page
