Lenze P500 series - Interfaces for Peripheral Devices; Ethernet Interface; Ethercat Interface

Electrical installation
Interfaces for peripheral devices
Ethernet interface
6
32
Lenze ¯ BA_p500 ¯ 3.0
6.4 Interfaces for peripheral devices
6.4.1 Ethernet interface
Figure Connection Connection type Cable type
X3 / X4:
Ethernet
X3 LAN1b (internal switch)
X4 LAN1a (internal switch)
RJ45 socket
Network cable
CAT5e S/FTP
(recommended)
Max. cable length 100 m
IPC001
The Controller can be connected to the higher−level network via X3 (LAN1b) or X4
(LAN1a). If the application comprises several Controllers, these can be networked in a
line network via the second LAN interface.
Baud rates: 10 or 100 Mbps
 Note!
If the RJ45 plug connection is exposed to oscillating or vibrating stress:
¯ Use a strain relief in the immediate vicinity of the RJ45 socket.
¯ Select the contact surface on which the device is mounted as fixing
point of the strain relief.
¯ Comply with the related minimum bending radius of the cable used.
6.4.2 EtherCAT interface
Figure Connection Connection type Cable type
X2:
EtherCAT
RJ45 socket
Network cable
CAT5e S/FTP
(recommended)
Max. cable length 100 m
IPC001
 Note!
If the RJ45 plug connection is exposed to oscillating or vibrating stress:
¯ Use a strain relief in the immediate vicinity of the RJ45 socket.
¯ Select the contact surface on which the device is mounted as fixing
point of the strain relief.
¯ Comply with the related minimum bending radius of the cable used.