4
Pull the DC power cord towards the direction of the AC power
source through either the bottom or the side of the bed frame.
Pull the two motion sensors to the two sides of the bed frame.
Make the bed completely flat
with a flipping motion
.
DONE!
Insert the batteries into
the remote control.
HEAD BOARD
6
Uncoil the AC power cord, connect the DC power cord to the
power supply and then connect the power supply to the AC
power source.
AC Power Cord
AC Power Source
DC Power Cord
Power Supply
5
Install the mattress retainer bar one side after another.
HEAD BOARD
AC
Power Source
DC Power Cord
AAA
AAA
AAA
DC
Power Cord
HEAD BOARD
2
1
To Next Page
Loading...
