Leone ARROW - Page 15

USER MANUAL LEONE ARROW E-SCOOTER • 15
THROTTLE CONTROL
The E-Scooter uses a speed changing throttle grip. It is on the right side of the handlebar. Rotate
the throttle grip toward the seat to accelerate and rotate forward away from the seat to slow
down. It is suggested after acceleration to turn back 1/4 turn the throttle. This will increase your
range and increase your battery life.
THROTTLE OPERATING INSTRUCTIONS
1. Turn the key to the ‘ON’ position, then turn the Throttle Gradually to accelerate.
2. To prevent losing control of the vehicle, please turn the Throttle slowly until the speed increas-
es.
3. Do not turn the Throttle until you are in the position to drive.
4. To stop, release the throttle and apply the front and rear brake simultaneously. You can decel-
erate by slightly pressing the brakes to start regeneration mode.
5. To move, release the brakes and turn the Throttle gradually.
6. When you turn move the turn signal switch left or right and don’t forget to turn it o by center-
ing the button.
7.The brush-less motor makes a small electromagnetic noise when turning the Throttle to start.
This is normal.
8. Please, for your safety and security, take the key out when you are not riding.
POWER MODE SELECTOR
The power mode selector is located beside the throttle. If you are driving on a at or low hill road,
you will achieve a maximum range when you ride on low speed (economy mode, power mode
1) When you ride on moderate hills, you will achieve a maximum speed for the hill if you switch
to high power (power mode 3). When you ride on steep hill you should switch to high speed for
maximum performance. Power mode 2 is the in between setting.
1 - Eco = less speed, less torque
2 - Comfort = more speed, more torque
3 - Max power = maximum speed, maximum torque
For safety the E-Scooter always starts in power mode 1 = Eco
REVERSE DRIVE
The travel direction switch (D-R) is located on the right handlebar. The D (Drive) position is the
normal position for driving forward. The R (Reverse) position is used to drive the E-Scooter in
reverse. We recommend that you use the throttle with great care when using the R position.
Although the speed for reversing is limited, it is still advisable never to fully open the throttle!
CAUTION!
Before switching on the scooter, always check whether the button is in the D position.