16 • USER MANUAL LEONE ARROW E-SCOOTER
CAUTION!
BEFORE OPERATING YOUR E-Scooter MAKE SURE THAT THE THROTTLE GRIP IS NOT ROTATED TO
THE “ON” POSITION!!! MAKE ALSO SURE THAT YOUR THROTTLE IS NOT “STICKY” AND ROTATES
FREELY BACK TO THE INITIAL POSSITION.
The distance and speed depend upon various elements of the rider’s style and the road condi-
tions. A constant speed and less stops will ensure longer range. Other factors include weather,
vehicle condition, and battery charge. Drivers must be cautious when driving on rough roads, in
poor weather, or when the battery charge is low. Always check the battery gauge while you are
riding and be sure that it does not get too low too often.
OPERATING INSTRUCTIONS
The E-Scooter’s driving system consist of four main components :
- Battery
- Controller
- Throttle
- Motor
When the throttle is twisted, a signal goes to the controller, relevant to the angle of turning. Then
the controller draws from the battery current, relevant to the required speed, controlled by the
throttle and the power necessary to start the E-Scooter or drive it uphill. The higher the driving
speed is and the steeper the hill is, the lower the range of the E-Scooter is. A second battery can
be connected to extend the range. The main breaker switch under the seat works as a high cur-
rent protector. 60V DC to 12V DC invertor inverts the voltage to 12V. All light bulbs work on 12V.
The alarm works on 60V. It is vibration sensitive. No matter that it consumes very little amount of
power, it is recommended when the E-Scooter is stored for a long period of time the main break-
er switch to be turned OFF.
To Next Page
Loading...