TROUBLES SHOOTING
3) MODE
AUTO:
The light acts as an automatic sensor at night. When motion is detected, the light will activate at its maximum brightness.
If you select this option, you can set the lighting time and the sensitivity of the sensor simultaneously.
3H:
At dusk, the light will be low for 3 hours, and when motion is detected, it will turn to high. After 3 hours it will switch to
Auto mode.
6H:
At dusk, the light will be low for 6 hours, and when motion is detected, it will turn to high. After 6 hours, it will switch to
Auto mode.
Dusk to Dawn:
From night to dawn, the light will stay on low. When motion is detected, it will switch to highlight mode.
MAINTENANCE:
Any cleaning or maintenance of the lights should be done with the power turned off. The lamp should be wiped clean with a damp cloth.
Do not use any abrasive cleaning products on the lamp cap or motion sensor lens. Don't add paint to the lamp. Do not use
high-pressure nozzles for cleaning. Regularly check whether the silica gel or sealant is still in place and that the lamp is still firmly
affixed on the wall.
PROBLEM
CAUSE
CORRECTIVE ACTION
Light does not come on
at night when motion is
detected
No power is being delivered to the
light.
Another light source is causing the
security light to think it is daylight.
The wiring inside the electrical box
came loose.
Check that the circuit breaker and /or wall
switch power is on.
Turn off surrounding lights and/or re-aim
the sensor head.
After turning power off to the light,
reconnect any loose wiring.
The sensor is in a shaded area and
is fooled into thinking it is nighttime.
Shine a flashlight onto the light sensor.
Relocate the security light to a location
that allows enough light enter the sensor
during the daytime.
There is lighting, arc welding, mobile
sources or other such unstable light
nearby.
Relocate the light to another location to
avoid such light sources.
Security light comes on
during the day
The light flashes on
and off
1.
2.
3.
1.
2.
3.
1.
2.
The device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
LE Innovation Inc
3651 Lindell Rd Ste D, Las Vegas, NV 89103, USA
www.lepro.com
+
1 866-287-2558 cs.oc@lepro.com
Made in China Fabriqué en Chine
AUTO
Auto
3H
Low for 3 hOff On
6H Dusk to Dawn
Low for all night High
AutoLow for 6 h
To Previous Page
Loading...