www.lerdge.com
20
3.1- Assemble X-axis slider and heat sink
Button head
mechanical screw
3 x M5*30
3 x Small pulley
1 x Eccentric
nut
3 x M5
Self-locking nuts
Pneumatic
connector
Print head cooling block
M3 screws are pre-installed on the heat sink.
Button head
mechanical screw
2 x M3*16
Button head
mechanical screw
2 x M3*8
Stainless steel stud
2 x M3*10
Spacer column
2 x 5*8*8
The gaskets are an optional
accessory. If the pulley can run
smoothly without the gaskets,
it is not necessary to install
them.
Gasket
6 x 5*7*0.5
To Next Page
Loading...
