Need help?Do you have a question about the Lerdge iX and is the answer not in the manual?
Provides critical warnings about potential physical dangers during assembly if not handled carefully.
Explains using connection blocks to improve frame stability and verticality.
Guides Y-axis slider assembly, focusing on pulley and screw direction for structural integrity.
Details attaching the Y-axis belt and adjusting slider engagement with eccentric nuts.
Covers installing the Y-axis motor, belt, and synchronous wheel, noting cable clearance.
Guides Z-axis motor seat attachment, emphasizing vertical screw tightening.
Covers Z-axis motor installation, coupling, and endstop, with alignment tips.
Details X-axis slider assembly with pulleys and heat sink attachment.
Guides print head assembly, including thermistor, fan, and wiring.
Details Z-axis slider assembly with pulleys, nuts, and screws, ensuring proper spacing.
Covers extruder assembly, including bearing, spring, and gear screw tightening.
Details attaching the Z-axis lead screw to the coupling and fine-tuning motor position.
Guides attaching the platform and inserting the feeding tube.
General| Build Volume | 300 x 300 x 400 mm |
|---|---|
| Bed Temperature | Up to 120°C |
| Display | 4.3-inch Touch Screen |
| Firmware | Lerdge Firmware |
| Power Supply | 24V |
| Filament Diameter | 1.75 mm |
| Nozzle Diameter | 0.4 mm (default) |
| Print Speed | Up to 150 mm/s |
| Supported Materials | PLA, ABS, PETG, TPU, Wood |
| Frame Material | Aluminum |
| Connectivity | USB, SD Card |
To Next Page
