• Clean and lubricate any moving components.
• In case of rust, use some grease on it.
• Ensure there are not binding / sticking of the gates which can falsely trigger the
obstruction sensing unit.
• Regularly test the slider gate motor to ensure that the obstruction sensor unit is
operating properly.
Troubleshooting
·T;o~bjej·
"
;-_
...
,
..
;
Too weak to move
the gate
Motor stops when
sliding gates are
blocked
Sliding gate fails to
move back after
opening/closing
Remote control
(Handset) not
workin
Pos$ible;PrOblem
(friction) clutch
,Causers)
Pressure on friction
clutch is too small
Pressure on friction
clutch is too big
Worm gear and worm Worm gear and worm
are blocked magnetic switch
Battery may be flat
(DC only)
Low voltage
(DC only)
Solution(;)/
Increase the pressure
by adjusting the
pressure screw
Reduce the pressure
by releasing the
pressure screw
Disintegrate clutch
with the key and push
gate back and re-
adjust the position of
ma netic switch
Replace new battery
(DC only)
To Previous Page
Loading...