28
INPUT THE TEMPERATURE AND ALTITUDE AT WHICH THE CLUB SELECTOR SETUP WAS
MEASURED.
Once the striking distances have been input, press MODE and follow the steps below:
1) The last saved Temperature will be flashing in
the bottom portion of the display. If you wish
to input a temperature other than the one
shown, proceed to step 2. To save the shown
temperature, press MODE and skip to step
3 below.
2) Press POWER to begin incrementing through the Temperature
settings. The default setting is 75 degrees F (25 degrees C). Pressing
POWER will increment through a range of 30 degrees to 120
degrees F (0 degrees to 50 degress C) in 5 degree increments.
When the appropriate temperture is displayed, press MODE to
save your selection and move on to the Altitude input.
To Next Page
Loading...
