How to troubleshoot PWR LED OFF on Leuze electronic Transmitter?
If the PWR LED on your Leuze electronic Transmitter is off, the possible causes are: no supply voltage or a hardware error. First, check the supply voltage. If the issue persists, contact Leuze electronic customer service.
What to do if PWR LED is red flashing on Leuze electronic Transmitter?
If the PWR LED on your Leuze electronic Transmitter is flashing red, it could be due to an interrupted optical link, the absence of green and orange LEDs in the SIGNAL QUALITY indicator, a defective laser diode, or a temperature warning. Check the device alignment and clean the optical window. Also, rule out environmental factors like snow, rain, or fog. Finally, inspect the LSR LED to check the laser diode.
Why is the OLK LED OFF on Leuze electronic DDLS 508?
If the OLK LED is off on your Leuze electronic Transmitter, this indicates no optical data connection. This can be due to a soiled optical window, insufficient alignment, the range being exceeded, environmental influences such as snow, rain, or fog, or the transmitter being deactivated. Clean the optical window, eliminate any environmental factors, check the device alignment, and ensure the transmitter is activated.
What does PWR LED Red Continuous light mean on Leuze electronic Transmitter?
If the PWR LED on your Leuze electronic Transmitter shows a continuous red light, it indicates a device error. Check the operating state LEDs for temperature warnings/errors (TMP), optical link issues (OLK), error link problems (ERL), and laser pre-failure messages (LSR). Contact Leuze electronic customer service for further assistance.
What does ERL LED Orange Continuous light mean on Leuze electronic DDLS 508 Transmitter?
If the ERL LED on your Leuze electronic Transmitter displays a continuous orange light, it indicates a link error on the second device. This can be due to a missing link on the Ethernet cable connection or a SIGNAL QUALITY indicator without green and orange LEDs. Check the Ethernet cable connection on the second device and verify the device alignment, clean the optical window, and eliminate any environmental influences. Also, check the LSR LED.
What does ERL LED Red Continuous light mean on Leuze electronic Transmitter?
If the ERL LED on your Leuze electronic Transmitter displays a continuous red light, it indicates a link error on the first device. This can be due to a missing link on the Ethernet cable connection or a SIGNAL QUALITY indicator without green and orange LEDs. Check the Ethernet cable connection on the first device and verify the device alignment, clean the optical window, and eliminate any environmental influences. Also, check the LSR LED.
What does TMP LED Orange Continuous light indicate on Leuze electronic Transmitter?
If the TMP LED on your Leuze electronic Transmitter shows a continuous orange light, it means the operating temperature is slightly outside the specified range (up to 5 °C). Verify the ambient temperature and take steps to lower it if necessary.
What does TMP LED Red Continuous light mean on Leuze electronic DDLS 508 Transmitter?
If the TMP LED on your Leuze electronic Transmitter is showing a continuous red light, it indicates that the operating temperature is significantly outside the specified range (more than 5 °C). Check the ambient temperature and take steps to lower it.
What does LSR LED Orange Continuous light mean on Leuze electronic DDLS 508?
If the LSR LED on your Leuze electronic Transmitter displays a continuous orange light, the laser diode is nearing the end of its life. Contact Leuze electronic customer service to arrange for a laser diode replacement.
How to fix LINK LINK/ ACT OFF on Leuze electronic DDLS 508?
If the LINK/ACT LED is off on your Leuze electronic Transmitter, there is no cable-connected link to the connected device. Check the Ethernet cable connection.
General| Brand | Leuze electronic |
|---|---|
| Model | DDLS 508 |
| Category | Transmitter |
| Language | English |
To Next Page
