What to do if ambient temperature is too high for Leuze electronic MLC 530?
If the ambient temperature is too high for your Leuze electronic Lighting Equipment, ensure correct environmental conditions.
Why is the signal weak on my Leuze electronic MLC 530?
If your Leuze electronic Lighting Equipment has a weak signal, it might be due to contamination or poor alignment. Clean the front screens of the device and then check the alignment of the transmitter and receiver.
How to troubleshoot transmitter without supply voltage in Leuze electronic Lighting Equipment?
If the transmitter of your Leuze electronic Lighting Equipment lacks supply voltage, check the power supply unit and the electrical connection. If necessary, replace the power supply unit.
What to do if the control circuit is open in Leuze electronic Lighting Equipment?
If the control circuit is open in operating mode 1, 2, or 3 on your Leuze electronic Lighting Equipment, close the input circuit with the correct polarity and timing.
What to do if ambient temperature is too low for Leuze electronic MLC 530 Lighting Equipment?
If the ambient temperature is too low for your Leuze electronic Lighting Equipment, ensure correct environmental conditions.
What to do if EDM operating mode changed during operation of Leuze electronic MLC 530 Lighting Equipment?
If the EDM operating mode changed during operation of your Leuze electronic Lighting Equipment, check the correctness of the selected operating mode, correct the operating mode if required, and restart.
How to fix short circuit against GND at OSSD1 on Leuze electronic MLC 530 Lighting Equipment?
If there is a short circuit against GND at OSSD1 in your Leuze electronic Lighting Equipment, check the wiring and exchange the cable if applicable.
How to fix short circuit against +24 V at OSSD1 on Leuze electronic MLC 530 Lighting Equipment?
If there is a short circuit against +24 V at OSSD1 in your Leuze electronic Lighting Equipment, check the wiring and exchange the cable if applicable.
What to do if receiver and transmitter channels are mismatched on Leuze electronic MLC 530 Lighting Equipment?
To resolve the issue where the receiver is set to C1 and the transmitter to C2 on your Leuze electronic Lighting Equipment, set both the transmitter and receiver to the same transmission channel and ensure they are correctly aligned.
What to do if reset button actuation duration exceeded on Leuze electronic MLC 530?
If the actuation duration (2.5 min) has been exceeded for the reset button or the cable is short-circuited on your Leuze electronic Lighting Equipment, press the reset button. If the restart is unsuccessful, check the wiring of the reset button.
General| Type | Light Curtain |
|---|---|
| Series | MLC 500 |
| Resolution | 14 mm, 30 mm |
| Protection Rating | IP65, IP67 |
| Current Consumption | ≤ 200 mA |
| Connection | M12 connector |
| Housing Material | Aluminum |
| Safety Level | Type 4 |
| Supply Voltage | 24 V DC |
| Operating Temperature | -30°C to +55°C |
To Next Page
