What to do if LED 1, red is ON at the receiver of my Leuze ELC 100?
If the LED 1 is red and constantly on at the receiver of your Leuze Light Fixture, it indicates that the OSSD is off. To resolve this, remove any object obstructing the protective field or try realigning the sensor.
Why is LED 1 flashing (10 Hz) red at the receiver of my Leuze Light Fixture?
If the LED 1 is flashing red at 10 Hz on your Leuze Light Fixture receiver, it indicates a device error. The suggested solution is to replace the receiver.
How to fix LED 2, green OFF on my Leuze ELC 100?
If the LED 2 is green and off on your Leuze Light Fixture, it means the transmitter isn't getting power. Check the power supply unit and the electrical connection. If necessary, replace the power supply unit.
What does it mean if LED 1 is flashing (10 Hz) red on my Leuze Light Fixture?
If the LED 1 is flashing red at 10 Hz on your Leuze Light Fixture, this indicates a device error. You should replace the transmitter.
What to do if LED 1 is flashing (0.5 Hz) red at the receiver of my Leuze ELC 100 Light Fixture?
If the LED 1 is flashing red at 0.5 Hz on the receiver of your Leuze Light Fixture, this indicates an OSSD error. Check the electrical connection of the safety outputs.
Why does my Leuze ELC 100 have short pulses LED 3, blue at the receiver?
If the LED 3 is showing short blue pulses on the receiver of your Leuze Light Fixture, it means the light reception is disturbed. Check the input area of the receiver for any ambient light sources.
General| Brand | Leuze |
|---|---|
| Model | ELC 100 |
| Category | Light Fixture |
| Language | English |
Details the correct application and potential improper uses of the safety sensor.
Outlines the qualifications required for personnel handling the device.
Defines the responsibilities of the manufacturer and operator for safe operation.
Covers positioning, alignment, safety distance calculation, and interference prevention.
Details the M12 connector pinouts for transmitter and receiver models.
Provides detailed steps for correctly aligning the transmitter and receiver.
Describes tests required before initial use and after changes to the machine.
Guide to identifying and resolving issues based on LED indicators.
Detailed breakdown of LED states, causes, and corrective measures.
To Next Page