Features
Overview
1
Product Display
2
◆
◆
◆
◆
◆
◆
◆
◆
◆
PoE Standard:
Flow control method:full duplex adopts IEEE 802.3x ,half duplex adopts Back pressure.
Port supports Auto MDI/MDIX.
supports lightning protection(secondary level requirements).
Single port supports PoE power:30W(first port outputs
Exchanging Mechanism: Store and forward.
All ports support exchange at wirespeed.
Zero-configuration:automatically supply for adaptive devices.
Panel indicator monitors operating status and helps fault analysis.
IEEE802.3af/at PoE++/HiPoE, support all ports standard detection.
Support power supply for PoE devices such as AP and network monitoring cameras connected by
Cat5/6 ethernet cables.
Port
HiPoE_60W).
◆
Automatically detecting and supplying power for powered devices conformed to IEEEE
802. 3af/at PoE++/HiPoE, unmanaged PoE switch supports first port output HiPoE_ 60W. It can
provide a convenient service for PoE network equipments like wireless access points(AP) and IPC
surveillance cameras.
Function Switch
Mark Mode
Description
N
V
S
Standard Normal
Port Isolation
Super Mode
All ports communicate freely,adapting to common data transmission environment
Switch to VLAN mode;downlink isolating from each other,uploads and downloads data
through uplink;suppress network failure like broadcast storm and virus attack
Downlink speed limitation:10M(Ultral-far transmission:250 meters)
Indicator
Status
Always ON
Always OFF
Flashes
Port circuit or cunrrent over-loaded
Port Isolation LED：V
Super Mode LED：S
Port Isolation mode ON
Super mode ON
PoE LED
Orange
Green
Powered equipments connected and power supply narmally
No powered equipments connected or no power supply
Network signal communicated
Network signal not communicated
Indicator
Description
Normal
Power Unconnected
Always ON
Always ON
Always ON
Always OFF
Always OFF
Always ON
Power LED:P
PoE Link
8FE P oE+2G E UP8FE P oE+2G E UP
Hyb rid PoE S witchHyb rid P oE Swit ch
1
2
3 4 9-UP 10-U P
5
6
7 8
100M PoE port 1000M Uplink
Function switchIndicator
To Next Page
Loading...
