E. PPP over Ethernet
1. WAN Type: Choose PPP over Ethernet.
2. PPPoE Account and Password: The account and password your ISP assigned to you.
3. Primary DNS: You can indicate IP address of primary DNS if required.
4. Secondary DNS: You can indicate IP address of secondary DNS if required.
5. Connection Control: There are 3 options to start connection:
Auto Reconnect (Always-on): The device will always try to link to Internet.
Connect-on-demand: The device won’t try to connect to Internet until LAN PCs or
devices try to go to Internet. Once Internet connection is established, this device will
drop the connection if maximum idle time is reached.
Manually: The device won’t try to connect to Internet until users press “connect”
button at Status page. Once Internet connection is established, this device will drop
the connection if maximum idle time is reached.
6. Maximum Idle Time: the amount of time of inactivity before disconnecting your PPPoE
session. Set it to zero or enable “Auto-reconnect” to disable this feature.
7. PPPoE Service Name: Optional. Input the service name if your ISP requires it.
8. Assigned IP Address: You can input a IP address if you got a fix IP address from ISP.
9. Maximum Transmission Unit (MTU): Most ISP offers MTU value to users. The default
MTU value is 0 (auto).
10. NAT disable: You can disable NAT feature if required.
To Next Page
Loading...
