FAQ and Troubleshooting
What can I do when I have some trouble at the first time?
1. Why can I not configure the router even if the cable is plugged in the ports of Router and
the led is also light?
A: First, make sure that which port is plugged. If the cable is in the Wan port, please change to plug in LAN
port 1 or LAN port 4:
Then, please check if the Pc gets IP address from Router. Use command mode as below:
If yes, please execute Browser, like Mozilla and key 192.168.1.1 in address.
If not, please ipconfig /release, then ipconfig /renew.
Whatever I setup, the pc can not get ip. Please check Status Led and refer to the Q2:
2.Why can I not connect the router even if the cable is plugged in LAN port and the led is
To Next Page
Loading...
