Lever GO+ User Manual

User Manual
Boulder, Colorado
FOR MORE INFORMATION AND VIDEO SET UP
1. Put on the LEVER shorts.
2. Secure straps. Tighten velcro
leg wraps.
*WARNING*: Do not over
tighten.
Short Assembly
Wash inside out on cold.
Please hang dry to
extend the life of your
shorts.
Short Care
User Warnings
Read user manual before use
Only use with compatible treadmill arms
Do not use if any parts are damaged or destroyed
Do not tighten past 45Ibs
Do not tighten the bungee or reduce weight while treadmill is in motion
@levermovement
www.levermovement.com
inquiry@leverrunning.com
CONTACT US

Lever GO+ Specifications

General

Brand	Lever
Model	GO+
Category	Fitness Equipment
Language	English

Summary

Product Information and Warnings

Short Assembly

Instructions for putting on and securing the LEVER shorts with velcro leg wraps. Avoid over-tightening.

Short Care Instructions

Guidelines for washing shorts inside out on cold and hanging them to dry to extend their life.

Critical User Warnings

Essential safety guidelines for using the LEVER system, including manual reading, damage checks, and weight limits.

LEVER GO+ Setup Steps

Setting Up the LEVER GO+ Base

Positioning and securing the LEVER GO+ base onto treadmill arms with pulleys at the rear.

Attaching the LEVER GO+

Securely strapping the LEVER GO+ base onto treadmill arms using rubber straps.

Adjusting Front and Back Sides

Adjusting the front and back angle mechanisms of the LEVER GO+ base for desired positioning.

Extending Bars

Extending the front and rear bars of the LEVER GO+ system until they click into place.

Assembling the Bungee

Threading the bungee through the system's pulleys and connecting it to the front left Cube.

Ready for Use

Engaging the LEVER system by pulling the bungee through the CamJam and securing it up to 45lbs.