1. Keep the uni t a wa y from childre n .
2. Maintain equipment dry, rain, moisture and all kinds of liquids or moisture can contain minerals,
corrode ele ctronic ci rcuit.
3. If the device is wet, please make it completel y dry.
4. Do not use or put the de vi ces in dus t or di rt s tora ge , it will damage the de ta chable pa rts and electroni c
components.
5. Do not use e quipment stored in overhea ting, hi gh tempe ra ture will shorten the servi ce life of ele ctroni c
devices, damage batteries, make some plastic parts deformation or melt.
6. Do not use e quipment stored in a cold place , or when the de vi ce te mpera ture to room tempera ture, its
internal will form the moisture, it will destroy circuit board.
7. Do not a ttempt to disassemble the equipment.
8. Do not throw, bea t or vibra tion e quipment, rough trea tment equipment can da mage the inte rnal
ci rcui t board a nd sophis ti cate d s tructure .
9. Do not use s trong chemicals, de te rgent or de te rgent to clean the devi ce .
10. Do not use pigment daub equipment, daub will block sundries in the re movable components a nd thus
affect the normal operation.
Environmentally friendly disposal
Old ele ctri cal appliances mus t not be disposed of toge the r wi th the residual
was te, but ha ve to be disposed of sepa ra tel y. The disposal a t the communal colle cting point via pri va te pe rsons is
for free. The owner of old appliances is responsible to bring the appliances to these collecting points or to similar
collection points. With this little personal effort, you contribute to recycle valuable raw materials and the
treatment of toxi c substances.
Caution
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used ba tte ries a ccording to the ins tructi ons.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
To Next Page
Loading...