Levoit LVAC-200 User Manual

13
Figure 3.5
Figure 3.7
CLEANING (CONT.)
1. Press the Dust Bin Release Button to
remove the dust bin. [Figure 3.5]
2. Pull out the post-motor filter (high-
eciency paper) from the vacuum
body. [Figure 3.6]
3. If necessary, clean the post-motor filter
with water. Allow the filter to air-dry
completely under the sun or in a dry,
ventilated place before reinstallation.
4. Push the post-motor filter back in the
vacuum body until you hear a click,
then replace the dust bin.
Periodically check the roller brush for hair or
debris. The roller brush will automatically shut
o if it is blocked or jammed.
1. Turn the vacuum o. Detach the
vacuum head from the stick by
pressing the Vacuum Head Release
Button.
2. Press the Roller Brush Release Button,
slide the side panel up to open, then
pull out the roller brush. [Figure 3.7]
3. If the roller brush is jammed, carefully
use a pair of scissors or a sharp knife
to remove any hair or debris tangled
around the roller brush.
4. Insert the roller brush back into the
vacuum head. Slide the side panel
down to lock it in place.
Post-Motor Filter Cleaning the Roller Brush
Figure 3.6

Levoit LVAC-200 Specifications

General

Brand	Levoit
Model	LVAC-200
Category	Vacuum Cleaner
Language	English