11
USING YOUR SMART AIR PURIFIER (CONT.)
Display Off
Light Detection
Timer
This turns o the display lights on the air
purifier, including button lights and indicator
lights (except the Check Filter Indicator).
You can turn on/o Light Detection in the
VeSync app. When this mode is turned on,
the light sensor will automatically adjust air
purifier settings based on the amount of light
in the room.
You can manually set the timer for 2, 4, or 8
hours using the button. You can also set
the timer for 1–24 hours through the VeSync
app.
• The display will automatically turn o when
the room gets dark. If the air purifier is in
Auto Mode or Pet Mode, it will not use the
high or turbo fan speeds, even if the air
quality is poor, to avoid making too much
noise.
• When the room becomes light again, the air
purifier will return to its previous settings.
The display will automatically turn back on,
and Auto Mode will no longer be limited.
1. Tap repeatedly to select a time. The
timer will start automatically.
1. Tap to turn o the display.
2. Tap any button to temporarily turn the
display back on. If you don’t tap another
button, the display will turn back o after
6 seconds.
3. Tap to turn the display back on. The
display will stay on.
Note: The Check Filter Indicator will still turn on
and stay on if it’s time to check your filter (see
page 17).
Note:
• The indicators are not buttons and
cannot be used to select a time.
• The timer indicators will light up blue
when active.
• When the timer is set through the
VeSync app, the indicator will light
up instead. Once the timer has finished,
the air purifier will turn o.
Note:
• You can change the fan speed at any
time while the timer is on.
• The timer will restart if the time is
changed.
2. To cancel the timer, tap until all timer
indicators are o. You can also turn the
timer o in the VeSync app.
To Next Page
Loading...
Need help?
General
