Lewis 150-2 - Page 31

30
Part No.
18-869
18-870
18-872
18-892
18-895
18-900
18-906
18-909
18-918
18-919
18-921
18-922
18-923
18-924
18-939
18-955
18-974
20-31
20-34
20-35
20-60
20-79
20-80
20-120
20-129
20-142
21-75
21-193
21-213
21-250
21-251
21-274
21-300
Plate
5
5, 6, 9
5
5
5
5
*
5
4
6, 9
5
4
4
4, 5
8
*
11
*
11
9
3, 11
*
5
5
7, 8
11
4, 7, 8
10
2
8
8
9
5, 9
PAR'IS LIST
Description
Pivot Bearing Screw, for disc cradle 140-11 in
cylinder base
Hexagonal Shoulder Screw, in link 46-164 to
connect cranks 48-127 and 48-150 in base
Shoulder Bearing Screw, for feed plate holder
in cylinder base
Stop Screw, for regulator 149-28 on top of
cylinder base
Hinge Screw, for regulator handle 76-12 on
top of cylinder base
Screw, for cap of ball joint 4124-51 in cylinder
base
Flat Head Screw, (4 used) to fasten work plate
4-C114 to bracket
Screw, for adjusting spring tension for cradle
140-11 in cylinder base
Taper Bearing Screw, for feed plate in cylinder
base
Hexagonal Clamp Screw, for crank 48-150 in
base of arm
Flat Head Screw, for regulator dial plate 110-224
on top of cylinder base
Adjusting Screw, in regulator 107-51 to adjust
depth of needle penetration
Adjusting Screw, in 18-922 screwto limit height
that disc can be raised
Set Screw, in regulator to lock 18-923 in place
Hexagonal Screw, for work table bracket 50-211
and 50-227
Screw, for holding machine to bench
Screw, for 41-48
Nut, for looper carrier 4118-15
Nut, for automatic tension release staff. Models
150-2 -3 -32 -33
Nut, for r:crew' 18-749 in cylinder base
Nut, on head to adjust thread tension
Nut, on plunger 426-47 in head, for changing
length of stitch
Nut, for locking ridge forming disc on shaft in
cylinder base
Nut, to adjust pressure of ridge forming disc
in cylinder base
Adjusting Nut, for applying tension to feed plate
Adjusting Nut, for 68-21 (2 used)
Spring, for feed plate holder
Spring, for cloth retainer on presser foot
Spring, for ball 79-31 in stitch regulator 149-16
in head
Long Spring, on bracket 50-211 for pin 22-189
in work plate assembly 404-126
Short Spring, on bracket 5 0-211 for pin 22-189
in work plate assembly 404-126
Spring, for latch 51-21 for locking disc
Spring, for ball 79-31 in ridge forming disc
regulator on top of cylinder base, and for skip-
stitch selector 4155-18
From the library of: Superior Sewing Machine & Supply LLC