Lewmar CPX - Page 29

Lewmar CPX Vertical Winlass ref 66300104 Iss. 5 | 29
7.4 Electric specifications
8. Trouble shooting
1. Anchor rode pays out independently while windlass is not in use.
This problem is a result of not securing the anchor rode combined with the gypsy drive cap being slack.
Tighten the gypsy drive cap using the winch handle and always secure the anchor rode independently of the
windlass when not in use.
2. Failure to operate or sluggish operation.
 The majority of these problems are electrical in nature. It is essential that the proper voltage be maintained.
The proper voltage on a 12 Volt system is 13.5 Volts (24 Volt system is 26.5 Volts), constant low voltage will
damage motor.
 Ensure electrical cable size is large enough to handle the current draw and keep voltage drop within
acceptable limits.
 Check control switches, connections, battery condition, isolator switch, fuse and motor for operation failure.
8.1 Electric windlass
MODEL
NORMAL
CURRENT
DRAW
TOTAL WEIGHT
GYPSY ONLY
TOTAL WEIGHT
GYPSY/DRUM
CIRCUIT BREAKER
A KG LB KG LB A
CPX1
112 17.5 38.5 20 44 90
CPX2
121 17.5 38.5 20.5 45.1 90
CPX2
74 17.5 38.5 20.5 45.1 50
CPX3
131 20 44 23 50.6 110
CPX3
70 20 44 23 50.6 90
CPX4
125 26.5 58.3 33.5 73.7 150
CPX4
70 26.5 58.3 33.5 73.7 110
CPX5
120 28.5 62.7 35.5 78.1 150
CPX5
60 28.5 62.7 35.5 78.1 110
MODEL
POWER
OPTION
MOTOR TYPICAL MAX. PULL MAXIMUM LINE SPEED TYPICAL WORKING LOAD
V W KG LB M/MIN FT/MIN KG LB
CPX1
12 700 750 1653 28 92 188 414
CPX2
12 700 850 1874 29 95 213 470
CPX2
24 900 850 1874 29 95 213 470
CPX3
12 1000 1025 2260 39 128 257 567
CPX3
24 1000 1025 2260 39 128 257 567
CPX4
12 1600 1250 2750 25 82 313 688
CPX4
24 2000 1500 3300 27 90 375 825
CPX5
12 2000 1450 3190 27 90 363 798
CPX5
24 2000 1600 3520 29 97 400 880