Lexicon MC-12 Upgrade Instructions

MC-12 to MC-12 Balanced Upgrade Instructions
Lexicon
8
14. Position the unit on its feet, as shown in the
illustration at the right. Connect the inserted end of
the XLR board cable to location J33 on the bottom
of the analog board.
15. Slide the analog board into the chassis as shown in
the illustration at the right, making sure the analog
board connectors are lined up with the
corresponding holes in the rear panel. Be careful
not to pinch cables or hit the opto/mic board.
(The opto/mic board is located between the main
board and the analog board, directly behind the
MICROPHONE INPUTS on the rear panel.)
16. Re-attach the analog board to the chassis by
replacing the screws that were removed in Steps 5
and 6 (page 6). Replace the internal screws first
(Step 6).
17. Re-attach the five cables removed in Step 4 (page 5.)
18. Re-attach the top cover, sliding it toward the front
panel and replacing the 12 screws that were
removed in Step 2 (page 4).

Lexicon MC-12 Specifications

General

Brand	Lexicon
Model	MC-12
Category	Controller
Language	English