To Next Page
R
Ronald BrownJul 30, 2025
What to do if Lexicon Controller says speaker is out of phase?
- RrobertsonsabrinaJul 30, 2025
If the Lexicon Controller indicates a speaker is out of phase, first check the connections between the speaker and the amplifier to make sure the wires aren't crossed. If the wiring is correct, you can ignore the message, as some speakers may report a phase error even when there isn't one. This error may also occur with dipolar loudspeakers, particularly if at least half the microphones detect out-of-phase calibration noise signals.
General
