MV-5 Setup
3-13
INPUT SETUP
Selecting the SETUP menu INPUT SETUP option opens the INPUT SETUP menu, a two-screen menu which sets up the input type and name, the
digital and analog inputs for both audio and video, the listening mode, and other advanced input settings.
INPUT
Selects between the twelve different inputs available. The input
selected in this parameter identifies the input that is currently being
setup or modified. Inputs can be scrolled through and modified
without leaving the input setup menu. However, most input setup
changes do not take affect until after the OSD menu is exited.
Note: Selecting a different input in the input setup menu will also change
the front panel input selection to match. For example, if the Tuner input is
selected on the front panel and you change the Input parameter to HD,
the front panel HD input is also selected.
Most of the inputs are interchangeable, with the exception of the
Dock and PC inputs. These two inputs are “hard-wired” and do not
allow for user selection of the Audio In parameters. For more infor-
mation on these two inputs, refer to Section 5: PC & Dock Controls.
Note: When a source is active, changing some audio or video parameters
may cause the Main Zone audio to briefly mute the incoming source. If
Zone 2 is set to DOWN MIX, the Zone 2 audio will also briefly mute.
NAME
Allows the user to customize the name of the selected input. Custom
input names can include up to eight characters.
Note: A custom name cannot be assigned to the Tuner input.
To Customize the Name of the Selected Input:
1. Select the input and enter the Input Setup menu.
2. Select the Name parameter. Note that a blinking square appears in
the first letter position.
INPUT TYPE: VCR
SHARPNESS: 32
NOISE REDUCTION: ON
X-COLOR SUPPRESS: ON
DCDi INTERPOL: ON
FILM DETECTION: ON
FILM EDIT DETECT: ON
ADVANCED VIDEO 1
INPUT SETUP 1
INPUT: HD
A/D SAMPLE RATE: 48kHz
MODE FAMILY: STEREO
MODE: 2-CHANNEL
INPUT SETUP 2
DEFAULT SUR: USE LAST
ADVANCED VIDEO
A/V SYNC DELAY: 0 ms
TRIGGER 2: ON
ZONE-2 OUT: ANALOG
MAIN MENU
AUDIO CONTROLS
VIDEO STATUS
DISPLAY SETUP
SPEAKER/EQ SETUP
INPUT SETUP
SURROUND CONFIG
DOLBY CONFIG
MUTE LEVELS
POWER ON SETTINGS
SETUP
SETUP
FLESHTONE NR: ON
COMPNT ENHANCE: ON
BRIGHTNESS: 100
CONTRAST: 100
COLOR: 100
ADVANCED VIDEO 2
NAME: ________
VIDEO IN: HDMI 1
V-PROCESS: FAROUDJA
VIDEO OUT: AUTO
DIG AUDIO: HDMI 1
ANLG AUDIO: NONE
DIG/ANLG AUTO: ON
INPUT SETUPSETUP
INPUT
INPUT SETUPSETUP
NAME
To Next Page
Loading...
