Setup Lexicon
3-16
DIG AUDIO
Selects the DIG AUDIO parameter, which assigns one of the rear
panel digital audio input connectors to the current input. Available
selections include NONE, Optical 1-4, Coaxial 1-4, and HDMI 1-2.
The HDMI Audio & Video inputs, HDMI 1 & HDMI 2, are mutually
exclusive inputs - only one input is available at a time for each input
location. For example, while setting up the DVD input, if HDMI 2 is
selected for the Video Input, then HDMI 1 is not a selectable option
for the Digital Audio Input.
Note: Digital audio is not selectable for the PC and Dock inputs. Refer to
Section 5: PC & Dock Controls for more information.
ANLG AUDIO
Selects the ANLG AUDIO parameter, which assigns one of the rear
panel analog audio input connectors to the current input. Available
selections include NONE, Analog 1-6, 7.1 Analog, and 5.1 Analog.
Note: Analog audio is not selectable for the Dock and PC inputs. Refer to
Section 5: PC and Dock Controls for more information.
DIG/ANLG AUTO OFF, ON
Selects the DIG/ANLG AUTO parameter, which identifies if the MV-5
should switch to an analog signal source for an input where the
digital input source has been interrupted. This feature is particularly
useful with certain cable set-top boxes where the signal is normally
digital but occasionally changes to analog.
The parameter, when set to ON, identifies if there is both a digital
and analog signal present to the input. If this condition is true, then
the MV-5 prioritizes the digital signal over the analog signal. When
the digital signal is interrupted, then it switches to the analog signal.
Note: Digital/analog auto switching is not selectable for the Dock and PC
inputs. Refer to Section 5: PC and Dock Controls for more information.
MODE FAMILY LOGIC 7, DOLBY, DTS, DSP, STEREO
Identifies the Surround Mode Family that is initially applied to the
incoming audio streams for the currently selected input. Other
surround mode families may still be applied. For more information,
refer to the “Listening Modes” section found later in this chapter.
Note: The Mode Family and Modes are connected. The Modes are driven
by the Mode Family selection as well as by the incoming audio source. The
current running data stream dictates what Mode Family options are
available for selection.
MODE
Identifies the Listening Mode that is initially applied to the incoming
audio streams for the currently selected Mode Family. Other listening
modes may still be applied. For more information, refer to the
“Listening Modes” section found later in this chapter.
Note: The Mode Family and Modes are connected. The Modes are driven
by the Mode Family selection as well as by the incoming audio source. The
current running data stream dictates what Mode Family options are
available for selection.
INPUT SETUPSETUP
DIG AUDIO
INPUT SETUPSETUP
ANLG AUDIO
INPUT SETUPSETUP
DIG/ANLG AUTO
INPUT SETUP
SETUP
MODE FAMILY
INPUT SETUPSETUP
MODE
To Next Page
Loading...
