English
TIP
RING
SLEEVE
Tip Sleeve
Ring
TAP
A/B
TIP
RING
SLEEVE
Tip Sleeve
Ring
BYPASS
STEP
5
Footswitch and Footpedal
Connections
Footswitches connected via the rear-
panel footswitch jacks allow you to perform
register STEP and BYPASS functions and/
or to control TAP and A/B effect morphing.
Two momentary foot-switches can be wired
to a tip-ring-sleeve connector. A stereo Y-
connector allows two identical single
switches to be used.
Headphones
A stereo signal which is adequate to drive
high-efficiency headphones is available at
the left output,
provided no connections are
made through the right output
. This feature is
provided as a convenience for practice pur-
poses, and is intended to provide only mod-
est volume.
One footswitch is provided with your unit,
along with a set of labels to identify footswitch
functionality. If you are only going to be using
one footswitch,connect it to perform TAP and
A/B functions, or register STEP and BYPASS
functions, and label it accordingly.
TAPA/B
BYPASSSTEP
Use a second (optional) footswitch to control
the remaining footswitch functions.
TIP
RING
SLEEVE
Tip Sleeve
Ring
PEDAL
10-50K
Typical Pot(entiometer)
TipSleeve Ring
An expression pedal connected via the
rear panel pedal jack allows continuous con-
trol of selected front panel parameter.
To Next Page
Loading...
