42
* ENVELOPE Decreases ECHO FX LVL
ECHO FX LVL Delayed output into stereo glide
MOD FX LVL Undelayed input to stereo glide
FEEDBACK 1 Input/feedback mix (1=no feedback; 64=infinite repeat)
FEEDBACK 2 Feedback/cross-feed mix
RATE 1 Stereo glide rate
DEPTH 1 Stereo glide depth
RESONANCE 1 Stereo resonance
RATE 2 Autopan rate
DEPTH 2 Autopan width (min=center, max=L to R)
RESONANCE 2 Stereo glide cross-resonance gain
A
9 DEJA VU
Deja Vu
A is configured with a cascade looper with envelope
control of the looper's output level. The output of the looper is
fed into a panner which sprays the effect into a stereo glide.
The stereo glide is also fed directly by the inputs.
Echo
Fx Lvl*
Mod Fx Lvl
ECHO 1
PAN
Fbk 1
Fbk 2
ECHO 2
STEREO
GLIDE
Mod Fx Lvl
Rate 1
Depth 1
Res 1
Res 2
Rate 2
Depth 2
ENVELOPE decreases ECHO FX LVL, pulling the echoes down
out of the way of loud signals, and bringing them back up whenever
softer signals are received.
FEEDBACK 2 controls the mix of ECHO 1 feedback and ECHO 2
feedback. When this value is 1, this mix is all ECHO 1 feedback. At
64, the mix is all ECHO 2 feedback (producing the longest echoes.)
Between these extremes, ECHO 1 is fed by a mixture of the two
feedbacks. These intermediate settings produce echo rhythms that
change over time.
FEEDBACK 1 controls the mix of input signal and feedback mix
fed into ECHO 1. When FEEDBACK 1=1, there is no feedback. At 64,
only feedback is sent into the echoes. This creates an infinite loop.
Setting DEPTH 2 to 1, in effect, turns off the panner.
In the Preset, the panner and the stereo glide are turned off,
leaving just a simple echo ducking effect. Turn up DEPTH 1 and
DEPTH 2 to add modulation and panning.
To Next Page
Loading...
