34
* ENVELOPE Increases both rates
ECHO FX LVL Delayed mod output level
MOD FX LVL Undelayed mod output level
FEEDBACK 1 Input/feedback mix (1=no feedback; 64=infinite repeat)
FEEDBACK 2 Feedback/cross-feed mix
RATE 1 MOD 1 speed
DEPTH 1 MOD 1 depth
RESONANCE 1 Left/right cross-resonance gain
RATE 2 MOD 2 speed
DEPTH 2 MOD 2 depth
RESONANCE 2 Left/right resonance gain
A
5 AEROSOL
Aerosol
A has two modulators which interact to produce a
variety of modulation effects (flanger, vibrato, chorus, etc.)
The modulators feed two echoes which are configured as a
cascade looper.
ENVELOPE increases RATE 1 and RATE 2, so that loud signals
increase the speed of modulation. Using RESONANCE 2 alone
(RESONANCE 1=1) maintains a stereo image in the modulation
effect. RATE 1 and DEPTH 1 will affect left modulation and RATE 2,
DEPTH 2 will affect right modulation.
Using RESONANCE 1 (cross-resonance) mixes the left and right
modulation signals together. The rate and depth controls will affect
both left and right.
Having the two echoes cascaded doubles the maximum amount
of available delay time. FEEDBACK 2 controls the mix of ECHO 1
feedback and ECHO 2 feedback. When this value is 1, this mix is all
ECHO 1 feedback. At 64, the mix is all ECHO 2 feedback (producing
the longest echoes.) Between these extremes, ECHO 1 is fed by a
mixture of the two feedbacks. These intermediate settings produce
echo rhythms that change over time.
FEEDBACK 1 controls the mix of input signal and feedback mix
fed into ECHO 1. When FEEDBACK 1=1, there is no feedback. At 64,
only feedback is sent into the echoes. This creates an infinite loop.
The Preset is set to produce a very deep stereo flange with subtle
echoes.
Echo
Fx Lvl
MOD 1
Fbk 2
Rate 1*
Depth 1
Res 1
Rate 2*
Depth 2
Res 2
ECHO 2
Fbk 1
ECHO 1
Mod Fx Lvl
Mod Fx Lvl
MOD 2
To Next Page
Loading...
