3 To secure a network, restrict all network ports that are not used. For more information, see “Configuring the TCP/
IP port access setting” on page 41.
4 To allow remote management of SNMPv3, enable SNMPv3, and then disable SNMPv1,2. For more information, see
“Setting up SNMP” on page 29.
Note: Specify the user credentials for Read/Write and optionally Read/Only users. It is recommended that
authentication level is set to Authentication, Privacy.
5 If necessary, configure the audit logging. For more information, see “Configuring security audit log settings” on
page 30. If necessary, remote system log for events can be specified by identifying the syslog server and selecting
the appropriate settings. Specification of an e‑mail address for the administrator is encouraged with selection of
the events to be e‑mailed.
6 Create one or more security templates using the LDAP building block, and then assign them to the appropriate
access controls. For more information, see
“Using a security template to control function access” on page 20.
Security scenarios 58
To Next Page
Loading...
