Lexmark E250DN - Govt Laser 30PPM Special Build Mono Taa - Page 89

Diagnostic aids 3-11
4512-220, -230
9. Press and hold until all of the lights cycle to print Step 3 test page.
10. Press and release to change the <BA> light sequence to the number beside the darkest portion of the
vertical bar.
11. Press and release to move to the <CA> light sequences on the right side of the Step 3 test page.
12. Press and release to change the <CA> light sequence to the number beside the darkest portion of the
vertical bar.
See note on page 3-9. See note on page 3-9. z z z <BA>
See note on page 3-9. See note on page 3-9.
z z z
<CA>
z
Step 3 printout
(sample only; use actual sheet)