14. Wipe the developer roller with a clean lint free cloth and
re-install the developer roller. At this point we do not
recommend that any chemicals be used to clean this roller.
Install the keyed end of the roller to the gear side.
15. Install the gear plate and two screws.
16. Install the feed roller gear.
This gear has a tight fit, make sure it is fully seated.
LEXMARK E260 • 360 • 460 • X264 • 363 • 364 MFP TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS
© 2010 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact techsupport@uninetimaging.com
www.uninetimaging.com
To Next Page
Loading...
