Rear side removals
Rear door and cover removal
1 Open the rear door.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a
hot component, allow the surface to cool before touching it.
2 Remove the two screws (A).
A
3 Remove the rear door and cover.
Fuser removal
1 Remove the rear cover. See “Rear door and cover removal” on page 234.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a
hot component, allow the surface to cool before touching it.
2 Remove the right cover. See “Right cover removal” on page 186.
3 Disconnect the cable JEXIT1.
4600-830, -835, -895
Parts removal
234
To Next Page
Loading...
