Scanning
Using the automatic document feeder and scanner glass
Automatic document feeder (ADF) Scanner glass
• Use the ADF for multiple‑page or two-sided
documents.
• Load an original document faceup. For multiple‑page
documents, make sure to align the leading edge
before loading.
• Make sure to adjust the ADF guides to match the width
of the paper that you are loading.
• Use the scanner glass for single‑page documents,
book pages, small items (such as postcards or
photos), transparencies, photo paper, or thin media
(such as magazine clippings).
• Place the document facedown in the corner with the
arrow.
Scanning to a computer
Before you begin, make sure that:
• The printer
firmware
is updated. For more information, see the “Updating
firmware”
section.
• The computer and the printer are connected to the same network.
For Windows users
Using Lexmark ScanBack Utility
1 From the computer, run Lexmark ScanBack Utility, and then click Next.
Note: To download the utility, go to www.lexmark.com/downloads.
2 Click Setup, and then add the printer IP address.
Note: View the printer IP address on the printer home screen. The IP address appears as four sets of
numbers separated by periods, such as 123.123.123.123.
3 Click Close > Next.
4 Select the size of the original document, and then click Next.
5 Select a
file
format and scan resolution, and then click Next.
6 Type a unique scan profile name, and then click Next.
Scanning 68
To Next Page
Loading...
Need help?
General
