25. Install the bushing onto the developer roller shaft, turning
it so that the tab is facing down. This will lock the roller in
place.
26. Install the doctor blade spring.
27. Fill the hopper with the appropriate amount of toner.
Remember: the amount of toner that can be placed in the
cartridge is controlled by the chip. Install the fill plug.
28. Install the developer roller cover. Make sure the pins are
aligned correctly in the cover.
LEXMARK T650 SERIES • TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS
3232 West El Segundo Blvd., Hawthorne, California 90250 USA • Ph +1 424 675 3300 • Fx +1 424 675 3400 • techsupport@uninetimaging.com • www.uninetimaging.com
© 2009 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only. UniNet Imaging does not warrant downloaded information.
To Next Page
Loading...
