21
IPDS Printer and Host Setup Guide AS/400 and iSeries Twinax Printing Using the Adapter for SCS
5 If the job prints, but some characters are printed incorrectly, you should check the default code page setting.
Using the control panel MENU/Menus, select Option Card Menu > IPDS MENU > EMULATION > Default
Codepage. On printers, the next step is to select Codepages A-E or Codepages F-K or Codepages L-Z,
then select the proper code page from these groups. On MFPs, the complete list of code pages appear
beside Default Codepage.
6 If the job prints, but some bar codes print in the wrong size, refer to the Bar Code Size option in the IPDS
User’s Guide for more information. Using the control panel MENU/Menus, select Option Card Menu >
IPDS MENU > EMULATION > BARCODE > Bar Code Size.
7 Refer to
Chapter 10. Printer Messages and Problems
on page
54
for additional problem solutions.
8 Once the job prints, refer to the IPDS Emulation User’s Guide for information on changing other IPDS MENU
settings.
To Next Page
Loading...
