Why Lexmark All in One Printer feeds more than one sheet?
If your Lexmark All in One Printer feeds more than one sheet of print media, or a sheet is fed improperly, remove the print media in the printer paper path, and check the stack to ensure the print media has been loaded properly. Be sure to remove the top and bottom sheets of each ream of paper that is loaded.
What to do if some documents do not print on Lexmark All in One Printer?
If some documents are not printing on your Lexmark All in One Printer, it might be due to unavailable fonts within the documents. To resolve this: 1. Open the document in Adobe Reader. 2. Click the printer icon to open the Print dialog. 3. Check the 'Print as image' box. 4. Click 'OK'.
Why Lexmark All in One Printer held jobs do not print?
Held jobs on your Lexmark All in One Printer might not print because: * A formatting error has occurred. You can try to print the job (knowing that only part of it may print), delete the job, or free up additional printer memory by deleting other held jobs. * The printer has received invalid data. Delete the job.
What to do if Lexmark All in One Printer shows 'Paper Jam' after removing paper?
If the 'Paper Jam' message persists on your Lexmark All in One Printer after removing the jammed paper, you might not have pressed Continue or cleared the entire paper path. Clear the entire paper path, and then press Continue.
Why Lexmark All in One Printer rubber feed rollers do not turn?
If the rubber feed rollers do not turn to advance print media on your Lexmark All in One Printer, check the following: * The power cord is plugged firmly into the back of the 2000-sheet drawer. * The power cord is plugged into an outlet. * The outlet has power.
Why my Lexmark All in One Printer jobs do not print?
There are several reasons why your Lexmark All in One Printer might not be printing: * The printer may not be ready to receive data. Ensure that 'Ready' or 'Power Saver' is displayed before sending a print job. * The output bin could be full. Remove the stack of paper from the output bin. * The input tray might be empty. Load paper into the tray. * You might be using the wrong printer driver or printing to a file. Verify you are using the correct printer driver associated with your printer. If using a USB port, ensure you are running a compatible operating system and using a compatible printer driver. * There might be an issue with your MarkNet™ N8000 series internal print server. Verify that you have properly configured the printer for network printing. * You could be using t...
How to fix unwanted patterns when copying with Lexmark All in One Printer?
To resolve unwanted patterns (Moire) when copying a document in Photograph mode on your Lexmark All in One Printer, change the content mode to 'Printed Image' under Copy Æ Options Æ Content.
Why Lexmark All in One Printer unexpected page breaks occur?
If unexpected page breaks occur with your Lexmark All in One Printer, the job might have timed out. Set Print Timeout to a higher value from the Setup Menu.
What to do if Lexmark All in One Printer shows 'USB device unsupported'?
If the message 'USB device unsupported' appears when using a USB device with your Lexmark All in One Printer, the USB device you are using may not be supported or has an error. For information regarding tested and approved USB flash memory devices, see Printing from a USB flash memory device.
What to do if the control panel display is blank on Lexmark All in One Printer?
If the control panel display on your Lexmark All in One Printer is blank, turn the printer off, wait about 10 seconds, and then turn it back on. If the 'Ready' message does not appear, turn the printer off and call for service.
General| Print Technology | Laser |
|---|---|
| Functionality | Print, Copy, Scan, Fax |
| Print Resolution | 1200 x 1200 dpi |
| Max Copying Resolution | 600 x 600 dpi |
| Grayscale Half-Tones | 256 |
| Max Scanning Resolution | 600 x 600 dpi |
| PC Connection | USB, Ethernet |
| Fax Modem Speed | 33.6 Kbps |
| Fax Resolution | 300 x 300 dpi |
| Maximum Paper Size | Legal |
| Duplex Printing | Yes |
| Operating Systems Supported | Windows, Mac OS, Linux |
| Monthly Duty Cycle (max) | 200000 pages |
| Media Type | Envelopes, Labels, Plain Paper, Transparencies |
| First Page Out Time | 6.5 seconds |
| Network Connectivity | Ethernet |
| Connectivity | USB, Ethernet |
To Next Page
